Disksafe Usage
After executing the Disksafe software, a welcome screen was displayed where the software asks you to create a Privacy Zone.
Creation of a Privacy Zone was achieved simply by moving the Flash Disk slider bar up or down, either by using the mouse or the windows arrow keys to set the required amount of the drive for the privacy zone. A visual indication of the selected zone is highlighted in orange.
A privacy Zone of 128mb as an example:
The disksafe software also allows for the setup of the 3 following options:
Your password
Password confirmation
A password hint incase you forget your password
After entering all the required information,'OK' was selected and the Disksafe Format Warning screen was displayed where 'OK' was selected again to start the format process.
After formatting was completed, a message was displayed, asking for the EZ Drive to be plugged back into the USB interface on the PC and then the device was all ready to be used.
When plugged back into the PC only the public area was available for access from within Windows Explorer, and the Privacy Zone was not available for use without first launching the Disksafe software and entering the previously set password. Upon entering the right password, a new drive appeared with all the Privacy Zone visible for use.
At this point we should note, that if you are not happy with the settings you applied earlier during the Privacy Zone setup, you can change any of these settings, including full removal of a secured area, simply by clicking on the 'Settings' button in the Disk Safe login window and changing them as required.
|
